EFFECT OF HIGH-ENERGY NEUTRON SOURCE ON PREDICTING THE PROTON BEAM CURRENT IN THE ADS DESIGN

case. Throughout the simulation the signal’s DOA is − 20 ◦ .
6.2. Simulations
Figure 10 illustrates the steered response of the fast beam-
former at each stage with and without pruning; from left to right, stages 3 to 6 are shown. At stage 3 (left colu[r]

Reconfiguring Process Plans: A New Approach to Minimize Change 181
10.2 Related Work
The witnessed evolution of Parts/Products Families has made obvious the need for “Evolvable and Reconfigurable Process Plans”, which are capable of responding efficiently to both su[r]

We suggest that the effects shown above are based on the binding of the CSPs to DNA and RNA. However, other possible mechanisms are the inhibition of
transcription and or translation by interaction with proteins involved in this process or an increa[r]

We propose here to implement an optimization methodology of the blankets design with regards to various parameters such as the local spectrum or the mass to be loaded, with the objective of minimizing the final neutron source of the spent assembly while maximizing the transmutation performances of th[r]

Neutron scattering applications often require discriminating the elastic contribution from the inelastic contribution. For this purpose, correlation spectroscopy offers an effective tool with both pulsed and continuous neutron sources as well as several advantages: the analysis of the neutron veloci[r]

the ultra-short laser pulses with the target material is thermally confined, i.e., the thermal diffusion takes place within the irradiated area. Therefore, the femto-second laser pulses create minimal (when compared for example to nominal nanosecond laser pulses[r]

This paper presents the calculation results of neutron energy spectrum, neutron spatial distribution in the reflector using the above-mentioned materials. Besides, neutronic characteristics calculated for silicon doping irradiation holes in the reflector are also presented and the utilization capabi[r]

Electron volt (eV): The unit used to measure the energy of cosmic rays. Neutron: Particle in the nucleus of an atom that possesses no charge[r]

Present study was conducted to see the effect of different levels (0, 50, 75 and 100 ppm of concentrate) of choline chloride on in vitro fermentation process with rations of different energy content. Two rations were prepared having different energy levels (1.26 Mcal/kg NEL and 1.50 Mcal/kg NEL) and[r]

The paper shows the main results obtained in terms of neutron spectra at fixed distances from the source as well as their neutron fluence rate (total and direct) and ambient dose equivalent rate.

- Work in pairs to discuss about the advantages and disadvantages of using each alternative source of energy and the use of alternative sources of energy in the futur[r]

P , resulting in the increase in P ref / P in , is if the laser beam mainly irradiates at the molten pool at very low speeds. The molten pool absorbs a large portion of the beam energy near the surface, sub[r]

hc T
d) For these temperatures, the intensity varies strongly with temperature, although for even higher temperatures the intensity in this wavelength interval would decrease. From the Wien displacement law, the temperature that has the peak of [r]

Xem Thêm " EFFECT OF HIGH-ENERGY NEUTRON SOURCE ON PREDICTING THE PROTON BEAM CURRENT IN THE ADS DESIGN "

Xem Thêm " THE ONLINE IDENTIFICATION OF DOMINATED INTER AREA OSCILLATIONS INTERFACE BASED ON THE INCREMENTAL ENERGY FUNCTION IN POWER SYSTEM "

The lower ladder score characterized by lower number of missed rungs observed in rats chronically exposed to CPF indicates that the legs of the rats were frequently being held stationary above the rungs for a relatively longer period. This observation demo[r]

ized to the matrix shows an effect on T g as a function of filler content and only in the nano-scale version. Covalent immobilization of matrix molecules on the surface of the M-coated 10 nm silica particles leads to a stro[r]

4 Chapter 1 What Is Nuclear Fusion?
fusion could be developed as a source of energy was undoubtedly discussed, no practical plans were put forward. Despite the obvious technical difficulties, the idea of exploiting fusion energy in a contro[r]

obtained using Energy10 and eQUEST3.6. The results from these two models gave similar results. The study concludes that four components were clearly economically under given constraints: high-performance windows, compact fluorescent lighting, well insulated roofs and A[r]

Table 18. Analytical characteristics of the proposed methods for the determination of Cu, Pb, Ni and Cd in biodiesel using W as modifier and two sample preparation procedures
4. Conclusions
Multivariate optimization techniques are currently applied preferenti[r]

sidered in some studies but are not feasible owing to a lack of flexibility.
Engineering Problems
Designs for OTEC plants with power capacities on the order of 10 megawatts or more have been made, but actual plants have been much smaller, with outputs on