This Provisional PDF corresponds to the article as it appeared upon acceptance. Fully formattedPDF and full text (HTML) versions will be made available soon.Scan speed control for tapping mode SPMNanoscale Research Letters 2012, 7:121 doi:10.1186/1556-276X-7-121Aleksey V Meshtcheryakov[r]
torque, which is theoretically infinite in the absence of parameter variations, is a function of rotorleakage inductance and if it is reduced to such a level that maximum allowed torque exceeds its value,static instability will result. On the contrary, with orientation along stator flu[r]
order to comparing with the command values. Residual results are used to determine the optimum inverter switch states through a look-up table to supply for induction motor. As a result, torque can be controlled directly. The stator voltage being used for the estimation is obtained from[r]
hanamoto@life.kyutech.ac.jp, ahmad-ghaderi@edu.life.kyutech.ac.jp, tsuji@life.kyutech.ac.jpAbstract. The modified flux observer with an estimation error correct function for the sensorlesscontrol method of synchronous reluctance motor is presented. The validity of the propo[r]
position and the speed is developed in the way of eliminating the influence of the reluctance torque. The selection of suitable controller types and the calculation of the controller parameters, both depending on the electrical and mechanical behavior of the[r]
*++INDUCTIONMACHINEFig. 3.12 - Indirect (feed-forward) voltage fed rotor flux oriented induction machine.3.4. PERFORMANCE OF A ROTOR FLUX ORIENTED INDUCTION MACHINESome characteristic simulation and experimental results are given in this Section, that illustratebehaviour of[r]
Note that rotor flux remains constant during the torque variation, indicating that flux and torque controlare fully decoupled (change of stator q-axis current does not cause any variation in the rotor flux).When the reference speed reaches steady-state value the actual speed ove[r]
voltageFigure 2. Simulation model of the three-phase three-level inverter.MATLAB. This allows to specify the plant parameters, operating and starting conditionsvery easily. Based on the selected operating conditions, theinitial conditions for continuousand discrete time states are determined.[r]
*++INDUCTIONMACHINEFig. 3.12 - Indirect (feed-forward) voltage fed rotor flux oriented induction machine.3.4. PERFORMANCE OF A ROTOR FLUX ORIENTED INDUCTION MACHINESome characteristic simulation and experimental results are given in this Section, that illustratebehaviour of[r]
a. is proving to be effective in treatingb. has shown its proof of effectiveness with treatingc. may have proven effective treatment ford. is effectively proving in treatinge. have given a proven effectiveness in the treatment of197. The citizens' action committee has accused the city counsel[r]
ASTM D2887 Standard Test Method for Boiling Range Distribution of Petroleum Fractions by Gas ChromatographyASTM D2887 Standard Test Method for Boiling Range Distribution of Petroleum Fractions by Gas ChromatographyASTM D2887 Standard Test Method for Boiling Range Distribution of Petroleum Fractions[r]
(a) Response of test of the active and the reactive power (300VA/div.). (b) Response of test of the rotor current (8A/div.). Fig. 11. Response of steady state test of unitary power factor and the rotor current. Fig. 12. The stator voltage(18V/div.) and cu[r]
region d ue to a comp ressed range of bright outputvalues. This drawback motivates the requirement ofmore advanced algorithms to improve LDR image/videoenhancement performance. For instance, to improve thevisual quality of underexposed LDR videos, Bennett andMcMillan [ 9] proposed a vi[r]
cells (Fig. 4). Marked differences between FGF-2-heparin- and IL-1b-induced responses were seen with allconstructs. IL-1b did not change the luciferase activityof any construct although northern blotting of mRNApreparations of IL-1b-stimulated cells in the sameexperiment was positive ([r]
&im must be carefully desided according to the permanent magnet ma- terial and the design of magnetic circuit. Fig. 11 shows the output characteristics considering the de- magnetization limit. The d-axis armature current id is limited according to the demagnetization limit. As a resul[r]
Nút nhấn ONK1T: Time relay.Role thời gian.F3F: Control fuse with fusible element.Cầu chì điều khiển tích hợp phân tử nóng chảy.M1M: Motor.F1F: Main fuse with fusible element.Cầu chì chính tích hợp phân tử nóng chảy.Description of the circuit: Bản miêu tả mạch điệnThe control<[r]