COMPARISON OF DSR AND AODV ROUTING AD HOC PROTOCOLS IN ROBOTIC MANAGEMENT AND NETWORK

6. Energy saving techniques at routing layer
The problem of energy efficiency in MANETs can be addressed at different layers. In recent years, many researchers have focused on the optimization of energy consumption of mobile nodes, from different points[r]

When a node forwards a RREQ packet to its neighbors, it records in its routing tables the address of the neighbor node where the first copy of the RREQ was received. This fact helps nodes to establish a reverse path, which will be used to carry the response to the RREQ.[r]

− = +
min{1 CBR i i , 1,2,... n 1} , where CBR i is the channel busy ratio that sensed by node N i . K. Xu, etc. (Xu, Tang et al., 2003) adopted this idea and added a smoothing factor to mask transient effects. But they only considered the AB estimation at each node within the path <[r]

Energy Efficient Load Balanced (EFLBAODV) and compared it to the traditionally existing reactive routing protocol Ad Hoc on Demand Distance Vector (AODV) thus using the load balancing technique to improve the node to node communication in our network. Also our routing protocol will be energy efficie[r]

The main method for evaluating the performance of MANETs is simulation. In this paper performance of Ad-hoc On-demand Distance Vector (AODV) reactive routing protocol is studied by considering IEEE 802.11 and IEEE 802.15.4 standards. Metrics like average end-to-end delay, packet delivery ratio, tota[r]

may need to follow pointers to find it. However, the MIB provides a name for the array as if it existed, and allows network management software on individual routers to map table references into appropriate internal variables. The point is:
Although they appear to s[r]

System Flow Charts (Failure, Upgrade, and Replacement)
These can also be categorized under documentation. Here, you would create a flow chart outlining each “process” under the control of the IT department. This could be as simple as creating a new user account in your Directo[r]

ENTERPRISE 6500 AND 7600 SERIES DEVICES TRANG 4 MANAGEMENT PROTOCOLS Now that your network is installed and configured to provide all of the services needed, per your corporate security [r]

554 Applications: Internet Management (SNMP) Chap. 30
management. First, a single manager can control heterogeneous devices, including IP routers, bridges, modems, workstations, and printers. Second, the controlled entities may not share a common link leve[r]

Document! Document! Document!
If you’re the average network engineer, you do not like to be tied down to your desk typing away for hours at a time just to create a document explaining all the things you already know! The key here is not to document all network details for your benef[r]

In this paper, we propose a novel secured compression algorithm for an ad hoc network in which the packets are encrypted and compressed. The decompression and decryption using the same algorithm happens by a perfect synchronization between the sender and the receiver. It is observed that the propose[r]

Control and Management
N ETWORK M A N A G E M E N T is an important part of any network. However attractive a specific technology might be, it can be deployed in a network only if it can be managed and interoperates with existi[r]

The integration of Grid technologies into ASPs and SSPs can enable a much richer range of possibilities. For example, standard Grid services and protocols can be used to achieve a decoupling of the hardware and software. A customer could negotiate an[r]

There are many routing protocols proposed for WSNs to deal with challenges such as energy depletion and latency of data transmission from nodes to base station. Recently, researchers have focused on Chain-based protocols. CCBRP (Chain-Chain Based Routing Protocol) tries to decrease both energy consu[r]

IV. D ESIGN AND I MPLEMENTATION
Wireless network interface controllers (WNIC) works at the layer 1 and layer 2 of the OSI model. It is an essential component for wireless desktop computer, laptop, and mobile platform. A WNIC can be connected using the PCI bus[r]

4.1.1. Network model
We introduce our network model in Figure 4. We assume that all users transmitters and receivers are distributed on a plane. Let Tx 0 and Rx 0 denote the primary transmitter and receiver, while Tx i and Rx i are pairs of s[r]

Tài liệu tham khảo công nghệ thông tin Efficient core selection for multicast routing in mobile ad hoc networks