CCNA SECURITY LAB MANUAL VERSION 1 2 3RD EDITION LAB COMPANION

http://www.vnexperts.net MỤC LỤC NỘI DUNG TRANG PHẦN I GIỚI THIỆU VỀ CÁC THIẾT BỊ CISCO PHẦN II CẤU HÌNH CISCO ROUTER PHẦN III ĐỊNH TUYẾN PHẦN IV CHUYỂN MẠCH SWITCHING PHẦN V MỞ RỘNG MẠN[r]

route-map OSPF->EIGRP permit 20
Task 2.5 Breakdown
Commonly, with route redistribution there is more than one possible solution to resolve most issues. In this task, route tags were used to ensure that any new routes redistributed into EIGRP on R6 will not be passed back into EIGRP from O[r]

xxix
■ Chapter 2, “Networking Fundamentals,” introduces some of the terminology
used by networking professionals and various types of computer networks. It also describes how the OSI reference model networking scheme supports net- working standards. In addition, this chapter describes t[r]

TRANG 1 Solution Manual for Chemical Process Safety Fundamentals with Applications 3rd Edition by Crowl TRANG 2 Solution Manual for Chemical Process Safety Fundamentals with Applications[r]

TRANG 1 Solution Manual for Fundamentals of Complex Analysis with Applications to Engineering Science and Mathematics 3rd Edition by Sa TRANG 2 Solution Manual for Fundamentals of Comple[r]

Router#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF[r]

out BECN pkts 0 in DE pkts 0 out DE pkts 0
out bcast pkts 0 out bcast bytes 0
5 minute input rate 0 bits/sec, 8 packets/sec 5 minute output rate 0 bits/sec, 8 packets/sec pvc create time 01:43:21, last time pvc status changed 01:38:01 Bound to Vir[r]

TASK 2.7 VERIFICATION _Verify the dampening parameters:_ Rack1R6#show ip bgp dampening parameters dampening 15 750 2000 60 route-map DAMPENING 10 Half-life time : 15 mins Decay Time : 23[r]

TRANG 3 COPYRIGHT © 2009 INTERNETWORK EXPERT WWW.INE.COM 3 TASK 1.1 VERIFICATION _Verify that the port-channel is functional, for instance on SW2:_ Rack1SW2#show etherchannel 12 port-cha[r]

00:36:43: IP: s=10.0.0.1 (local), d=10.0.0.2 (Ethernet0), len 56, sending 00:36:44: IP: s=10.0.0.2 (Ethernet0), d=10.0.1.1, len 60, unroutable 00:36:44: IP: s=10.0.0.1 (local), d=10.0.0.2 (Ethernet0), len 56, sending
- L ệ nh Ping ở trườ ng h ợ p này không th ự c hi ệ n thành công, ta dùng l[r]

TRANG 1 STUDENT SOLUTIONS MANUAL containing selected solutions to FUNDAMENTALS OF MACHINE COMPONENT DESIGN 3RD EDITION BY ROBERT C.[r]

TRANG 1 STUDENT SOLUTIONS MANUAL containing selected solutions to FUNDAMENTALS OF MACHINE COMPONENT DESIGN 3RD EDITION BY ROBERT C.[r]

A packet with a source IP address of 141.X.37.100 is received inbound on R4 interface Fa0/1. With unicast RPF enabled, R4 would assume the source IP address must be spoofed as R4 will normally route via R5 to reach that particular subnet. This will cause R4 to drop this packet. Althoug[r]

Tasks 1.2 & 7.3 Verification
This task should be verified in conjunction with task 7.3. Apply Task 7.3 solution in order to perform complete verification. The preferred option at this point of the lab would be to temporarily hardcode R4’s IP address. Then, after full IP reachability[r]

Router(config)# ip route 172.16.20.0 255.255.255.0 172.16.10.2 200
- Theo m ặ c đị nh, m ộ t static route s ẽ đượ c gán giá tr ị AD là 1. AD c ủ a m ộ t route nói lên độ
tin c ậ y c ủ a route đ ó, AD càng th ấ p thì độ tin c ậ y c ủ a router đ ó càng l ớ n. AD là m ộ t giá tr ị[r]

CCNA1 SKILL BASED EXAMINATION
Duration: 80 minutes
Configuration requirements: (8 marks)
1. Calculating the subnet addressing for the lab using the VLSM technique and note all information needed on the topology. 2. In each LAN, configure the[r]

- Thông th ườ ng các máy xách tay ngày nay ch ỉ có các port USB, không có các port Serial. Vì v ậ y, b ạ n c ầ n trang b ị thêm m ộ t đầ u n ố i chuy ể n đổ i t ừ USB sang Serial (USB-to-Serial), hi ể n th ị trong hình 1-6.
Hình 1-3: Cáp Serial (2500)

TRANG 1 Solution Manual for Hydrologic Analysis and Design 3rd Edition by McCuen TRANG 2 Solution Manual for Hydrologic Analysis and Design 3rd Edition by McCuen TRANG 3 Solution Manual [r]

TRANG 1 Solution Manual for An Introduction to Combustion 3rd Edition by Turns TRANG 2 Solution Manual for An Introduction to Combustion 3rd Edition by Turns TRANG 3 Solution Manual for [r]

In this example, it has been determined that the root selection using default values has led to under- utilization of the available switch trunks. Therefore, it is necessary to force another switch to become the root switch for VLAN 99 to impose some load-sharing on the trunks.
Selection of the[r]