WINDOWS AUTOMATED INSTALLATION KIT WAIK USERS GUIDE FOR WINDOWS 7

Triển khai Windows 7 – Phần 1: Những cải tiến của Windows AIK 2.0
Lưu ý: Phần hai này vẫn được viết dựa trên phiên bản Windows 7 RC.
Tìm hiểu về DISM
DISM.exe là một công cụ dòng lệnh mới được tích hợp vào trong bản cài đặt mặc định của hệ điều hành Windo[r]

By default, the public profile is the most restrictive firewall profile, and the domain profile is the least restrictive in terms of the number of different types of traffic each profile allows .
In Windows Vista, only one firewall profile could be active at any one time even if your compu[r]

n EAP using MD5
Note that by default PAP and CHAP are not enabled as authentication protocols on new VPN connections you create using the Set Up A Connection Or Network wizard . This is because PAP and CHAP are not considered secure; use them only when connecting to ISPs whose network access d[r]

Doing this starts the New Inbound Rule Wizard, shown in Figure 26-12, which walks you through the steps of creating an inbound firewall rule by selecting the type of rule you want to create and specifying the conditions needed for the rule . Note that different pages may be displayed in t[r]

http://technet.microsoft.com/en-us/library/bb727035.aspx . For information about the different types of Ipv6 addresses usually assigned to an interface, see the section titled “Configuring and Troubleshooting Ipv6 in Windows 7” later in this chapter.
note Issues have arise[r]

CHapTER 24 Managing Client Protection
1156
n Configure Microsoft SpyNet Reporting SpyNet is the online community that helps
users choose how to respond to potential spyware threats that Microsoft has not yet classified by showing users how other members have responded to an[r]

To ensure that your endpoint is configured correctly, you can submit an HTTP request to the server. You can do this by opening your web browser and navigate to http://w2k3srvr/thresholds?wsdl. If the endpoint is responding, it will return the WSDL for your service.

• What configuration and management methods can be used for institution- and personally owned devices?
Ongoing Windows 8.1 device configuration and management is an essential part of your Windows 8.1 deployment plan. Windows 8.1 supports both on-premises and off-premi[r]

If, however, the link is your Internet connection or another network that is part of your in- tranet, your performance problems may be caused by overutilized network infrastructure . For example, if several computers are backing up their disk content to a folder on the network, a link can b[r]

ptg6432687
Windows® Server 2008 Hyper-V Unleashed Copyright © 2009 by Sams Publishing
All rights reserved. No part of this book shall be reproduced, stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without written[r]

Planning for the Use of Snapshots on the Hyper-V System . .................. 95
Summary . ........................................................................................................................................................ 96
Best Practices . .......................[r]

applications can accomplish their required functions.
user Access challenge
Will the application be accessed by employees from within the organization, from outside the organi- zation, from the public Internet? One technology may not be enough and the organization may have to support multiple t[r]

Dữ liệu Outlook được đặt trong hệ điều hành Windows 7 và Vista nằm ở: C:\USERS\*USERNAME*\APPDATA\ROAMING\THUNDERBIRD\PROFILES\*PROFILENAME*.DEFA ULT\MAIL Đối với Windows XP: TRANG 2 TRA[r]

Run hardware diagnostic software to verify that your hardware is not defective . These tools are typically built into or bundled with your hardware .
Check aTa Disk and Controller Settings
If your system uses ATA storage devices such as hard disks, determine whether the firmware setting Primary[r]

You can find network diagnostic information in two places in Event Viewer:
n Windows logs\System Look for events with a Source of Diagnostics-Networking .
These events detail troubleshooting options that were presented to the user (Event ID 4000), the results of the user’s choic[r]

n Verify that you correctly configured any jumpers or dual in-line package (DIP) switches Jumpers and DIP switches close or open electric contacts on circuit boards .
For hard disks, jumper settings are especially important, because they can adversely affect the startup process if not[r]

[r]

Plug the micro-USB connector end of the USB 1.
charging cable to the Solar Power Bluetooth Car Kit, and the other USB Type A connector end to any available SUB port on your computer or an AC power adapter with USB port (not included). The LED light on the Car Kit will light[r]

by system administrators. Any changes the user makes to this type of profile are lost when he or she logs off.
Note Mandatory user profiles are included with Windows XP and later only in order to provide backward compatibility with existing Windows NT 4.0 domains. If you have [r]

A dual-boot configuration makes it easy to boot multiple operating systems on a single TigerBox. (Note, the Windows complement should be installed and configured prior to Linux.) At the time of this writing, the Windows versions that are most stable and competent include Windows