ON LINE DETERMINATION OF THE ASH CONTENT OF COAL

The research results concentrate on physical-mechanical, geotechnical characteristic properties and technical solutions to promote properties of coal ash mixture.. Base[r]

3. RESULTS AND DISCUSSION
3.1. B-spline function and optimization
We applied the B-spline function for approximation of the plotted pattern of a pair of genes, prior to CoD estimation of coexpression. The shape of a curve fitted by B-spline[r]

In mix design of HPC, there are many factors considered in the selection of ingredients and their optimum
proportions are difficult. The mix design process of HPC is more critical than that of Normal Strength
Concrete (NSC) in view of high powder content and the requirement of low water cementitious[r]

2 Effect of simultaneous injection on combustion and gasification efficiency of solid injectants TRANG 4 the residence time of the pulverized coal in the high temperature field, it is al[r]

Figure 11. Graphic representation of speed vs. time during a load sudden decrease, obtained by: -.-,
applied the model (simulation) and taken measurements (continuous line).
Then one of the most important factors that has influence about the transient[r]

which was then passed to the weapons establishment at Aldermaston. In October of that year Britian’s first nuclear weapon was tested. More plutonium was needed and design started on a second station alongside Windscale, known as Calder Hall. Here, it was decided to make use of[r]

FIGURE 1: RESEARCH MODEL FRAMEWORK _Source: Author design _ 4.2 SCOPE OF THE STUDY - About content: The dissertation focuses on research on the efficiency of business activities of Vietn[r]

This article presents some results of the research on change of content, the expression of types of tasks related to the concept of integration and the technique of solvin[r]

Later the test scores were analyzed in the post-test stage for support of the content validity by examining if the content of the specific item needs reviewing based on t[r]

The microstructure of cast Al-4Si-Mg reinforced with fly ash particles at various particle contents has been studied. The composites were fabricated by stir casting process and characterized by optical microscopy, image analyzer, scanning electron microscopy and hardness measurements. The results sh[r]

Multi-Dimensional Analysis of Data Streams Using Stream Cubes 105 high levels, such as by region and by quarter (of an hour), making timely power supply adjustments and handling unusual situations. o
One may easily link such multi-dimensional analysis with the online a[r]

The research is mainly focused on: i determination of total phenolic, flavonoid and anthocyanin contents, ii evaluation of different types of extraction liquid–liquid, solid–liquid and sup[r]

y-coordinate is its vertical position on the plane. You denote the coordinates of a pointwith (x,y), where x is the point’s x-coordinate and y is the point’s y-coordinate.The center of the coordinate plane—the intersection of the x- and y-axes—is called theorigin. The coordinates of the origin are ([r]

REPORT ON OTHER LEGAL AND REGULATORY REQUIREMENTS [Form and content of this section of the auditor’s report will vary depending on the nature of the auditor’s other reporting responsibil[r]

) 20 C until use. The following steps were all run at 4 C. The cell paste was resuspended in 40 mL buffer B: 50 m m
Tris ⁄ HCl buffer, pH 8.0, 0.5 m NaCl, and the suspension was sonicated on ice for 70 s (seven 10-s pulses with inter- mittent 1-min cooling periods). A[r]

The method was applied for the determination of adsorption heat of p-nitrophenol, p-nitroaniline and 2,4-dinitrophenol on TW-2 and CAL 12 × 40 activated carbons.. With the approach, it[r]

c) Pulverizer Sizing. Base pulverizer selection on coal feed is required at maximum boiler load plus 10 percent for load pickup and continuous boiler output at maximum steam load. Pulverizer output varies with coal grindability index and fineness (percent through 200 mesh)